1971 Camaro wheel sizes that fit

Q: Key is stuck in the ignition and won't turn all the way back into the lock position

asked by on November 01, 2016

My key has been stuck in the ignition for a few weeks now and it's still been cranking up until yesterday. Turn the key and nothing. From what I've read it could be the ignition switch gone bad but I just noticed that the gear shift does not totally lock into park. What I mean is you can change the gears without pushing the button on the side of the gear shifter so I didn't know if this may be the problem since the key won't cut off or come out if the car is not in park .

My car has 999999 miles.
My car has an automatic transmission.

It is either the ignition switch electrical or the ignition lock cylinder. The key slides into the ignition lock cylinder. These two components mate together and essentially become one. So if either of them break, they will both be affected. In addition, there are many other small moving parts inside your steering column that are activated when you insert the key and turn it. Any of these parts could be the culprit.

One of the mechanism that is activated when you insert and turn the key is the shift interlock system. This system locks the shifter when you put it into the park. When you turn the ignition key and step on the brake, it releases the shift interlock system.

The steering column will need to be disassembled to see what has broken. At that point a replacement part can be ordered and the appropriate repair can be done.

In order to avoid any unnecessary repairs, consider getting the car’s no start condition inspected by a certified mobile technician, such as one from YourMechanic.

Good luck!

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・ Backed by 12-month, 12,000-mile guarantee ・ Fair and transparent pricing


Experienced Mechanic?

What others are asking

Piston return springs make noise

Without knowing what piston return spring you are talking about it will be hard to come up with a diagnosis for you. If you are talking about the rear brake return spring then you may have to have the rear ...

i have a 2005 dodge ram 1500 that makes a clicking noise when i turn what is this

If your vehicle is 4WD with CV axles in the front, a common cause of clicking and clunking in the circumstances that you describe is a faulty outer CV joint. Such can often be detected on visual exam and with ...

Car starts after a few tries, but then dies as soon as I take my foot off gas pedal.

Clean any debris on the battery posts using a mixture of baking soda and water. Under your battery is a pedal that connects to the PCM. Make sure that it is pushed down hard so that your battery does not ...

My car has had to have the exhaust manifold replaced four times in 17 years due to cracks in the manifold itself.

Unfortunately, cracks on the passenger side OEM exhaust manifold is a common problem with heavy duty use of this engine: work trucks, motor homes, school buses, where the engine is run at high loads for extended periods. They tend to ...

Stalling when driving, idling is rough, and gas seems to be use up quickly. It also hesitates when accelerating. There's no Check Engine Light on.

This may be a sign of a failing throttle position sensor or mass air flow sensor. As you may know, the mass air flow sensor monitors the air flow into the intake as it is mixed with fuel prior to ...

How do I break in the vehicle?

If you are purchasing your car new, you will need to break it in before you can drive it normally. The break in process lasts 600 miles, during which you should follow these guidelines: 1. Keep the engine operating between ...



© 2021 YourMechanic All rights reserved. Made with ♥ in Silicon Valley.